Sunnen Model CK-21 Vertical Hone
"Computer Controlled For Precision Performance"
S/N: 2WI-1136 New: 1997
Specifications:
Max. Bore Dia. (With CV Type Tooling - Not Included): 8"
Spindle:
4 H.P.
Two Speed Ranges - Manually Adjusted
Low Range 90-240 RPM Adjustable in 10 RPM Increments
Through Operator Interface
High Range 250-550 RPM Adjustable in 10 RPM Increments
Through Operator Interface
Stroker:
3/4 h.p.
Strokes per Minute: 40-100
Stroke Length Range: 3/4" to 12"
(Note: Stroke speeds exceeding 70 RPM are not recommended
for stroke lengths over 6.25". Severe Machine Damage Could
Result!!!)
Adjustable in 10 SPM Increments from Operator Station.
No Belts to Change.
Feed System:
Max. Operating Torque: 10 FT-LB
Feed system: 100% Computer Controlled
Max. Feed Rate: 0.030 IN/MIN
"Sizeloc" Zero Shutoff
Auto Retract at End of Cycle. Auto Rapid at Beginning of Cycle.
Spindle Pre-Load (Feed Start Point) Set at Operator
Interface. Always the Same Amount. Operator and
Cycle Independent for Constant Performance.
Two Stage Feed Profiling, Beginning or End of Cycle
Feed Reduction.
Spark Out Option
Tool Selection Menu from Operator Interface
Electronically Protected Overload System is Operator
Resettable. Backed Up by a Common Shear Pin. No
Gears to Replace.
Honing Fluid System:
Honing Fluid System is Synthetic Coolant Compatible. Check
with factor for Filter Recommendations.
Longer Life Progressive Cavity Pump
Flow Rate- 5 Gal/Min
Pullout Sump for Easy Cleaning
Canister Operating Pressure Gage for Filter Change Planning
and Diagnostics.
Auto/Manual Start of Coolant
Remote Manual Oil Control Valve.
Fully Adjustable Nozzle.
Reservoir Holds Max. 63.5 Gallons to 38 Gallons Min.
General Requirements:
Dry Weight: 3,000 LBS
Dimensions: Approx. 86" L x 87" W x 88" H
Compressed Air: 80 PSI
Maximum Part Weight: 1,500 Lbs.
Work Area Envelope: 57" x 35 x32"
Elecrics: 220 Volts, 3 Phase, 60 Cycle
Equipped With:
Tooling Set-Up
** Beautiful Condition & Appearance - Original Paint **
** Inspect Under Power in our Harriosn, NJ Warehouse **
CONTACTO 
