SHARP VERTICAL BED MILL
MODEL: KMA-2, S/N: 4226, MFG: 1995
SPECIFICATIONS:
TABLE WORKING SURFACE ............... 17.75" X 74.75"
NUMBER OF T-SLOTS ................... 5
RANGE: LONGITUDINAL (X) ............. 47-1/4"
CROSS (Y) ........................... 17-11/16"
SPINDLE HEAD (Z) .................... 21-5/8"
MAXIMUM/MINIMUM DISTANCE,
...SPINDLE NOSE TO TABLE ............ 25-5/8" / 3-15/16"
DISTANCE, CENTERLINE OF
...SPINDLE TO FACE OF COLUMN ........ 17-11/16"
DISTANCE FROM TABLE TOP TO FLOOR .... 33.5"
SPINDLE TAPER ....................... #50 N.S.T.
(12) SPINDLE FEEDS .................. 45-1,500 R.P.M.
(12) TABLE AND SADDLE FEEDS ......... 1-1/8 TO 34-7/16 I.P.M.
RAPID TRAVERSE RATE, LONG AND CROSS . 113 I.P.M.
(5) SPINDLE HOUSING FEEDS .0025, .00375, .005, .0075, & .01 I.P.R.
EQUIPPED WITH:
HEIDENHAIN THREE-AXIS DIGITAL READOUT
CAST IRON BOX-TYPE COLUMN CASTING
HARDENED AND GROUND BOX WAYS ON SADDLE AND COLUMN
ALIGN PNEUMATICALLY ACTUATED POWER DRAWBAR
POWER RAPID TRAVERSE FOR LONGITUDINAL AND CROSS FEEDS
PENDANT CONTROL
BACKLASH ELIMINATOR
WORK LIGHT
LEVELING PADS
AUTOMATIC LUBRICATION SYSTEM TO TABLE AND SADDLE WAYS
CHIBA ONE-SHOT LUBRICATION SYSTEM TO SPINDLE HEAD
COOLANT SYSTEM WITH 1/8 H.P. PUMP MOTOR
2 H.P. TABLE AND SADDLE FEED MOTOR
15 H.P. 3/60/220-440 VOLT SPINDLE DRIVE MOTOR AND ELECTRICAL CONTROLS
MACHINE IS WIRED FOR 440 VOLT OPERATION.
CONTACTO 
